Page under construction (7/9/2024) ---+ Evolution Experiments ---++Introduction In general there are two kinds of evolution experiments: adaptive evolution and [[ProcedureBacterialMutationAccumulation][mutation accumulation.]] In adaptive evolution experiments cells within a culture compete with each other and trend towards an increase in fitness. These experiments are useful for identifying mutations that improve a particular function, such as growth on a particular compound or resistance to a particular stress. Individuals with detrimental mutations are usually out-competed, thus the mutations evolved in these experiments is usually biased towards beneficial mutations. Mutation accumulation experiments, on the other hand, reduce or remove selection, allowing the persistence of all types of mutations and are thus useful for calculating overall mutation rates or examining the spectrum of possible mutations. ---++Experimental design An overall evolution experiment will likely involve three phases: 1) inoculating populations, 2) routine transfers, and 3) isolating clones and freezing stocks. *1) Inoculating populations* Regardless of whether they are adaptive or mutation accumulation experiments, evolution experiments should be started by streaking the ancestral stock onto an agar plate and then initiating each population from a separate isolated colony. This reduces the impact of mutations that may already be present in the ancestral stock and ensures that the populations begin as single genotypes. After the first day of growth populations should be frozen so they can be sequenced and referred to later, in particular when determining whether identical mutations shared between samples evolved during the experiment or were present in the initial culture. *2) Routine transfers* Over the course of an evolution experiment the populations will be transferred to fresh media to continue growing after their initial media has been used up. Designing an effective evolution experiment requires taking into account the impact of: * Volume of transfers * Timing of transfers * Stress conditions. *3) Isolating clones and freezing stocks* At the end of the transfer period the evolved strains should be [[ProtocolsFreezingStrains][frozen]] for further analysis. For an adaptive evolution experiment this can be done as populations by freezing a milliliter of culture from the last transfer and/or as isolates by streaking each population on a plate and inoculating a large, isolated colony into fresh media and then freezing it. Similarly, colonies from the last transfer of mutation accumulation experiments should be inoculated into cultures and frozen. ---++Analyzing evolution experiments The end result of an evolution experiment is likely isolated, evolved clones that have acquired additional mutations relative to their ancestor. The goals, then, are usually to identify these mutations in the genome and determine what their functional consequences, if any, are. These can be accomplished by sequencing the isolates' genomes and comparing them to the ancestor with breseq and performing [[ProceduresLongTermCompetitions][fitness assays]] or other functional assays, respectively.
This topic: Lab
>
WebHome
>
ProtocolList
>
ProceduresEvolutionExperiment
Topic revision: r1 - 2024-07-09 - IsaacGifford